Inner Range - Concept: 4 Door Access Module

Control

Terminals

The Intelligent 4 Door Access module has been specifically designed to meet the highest levels of system integrity and redundancy planning. The Intelligent 4 Door Access module effectively combines offline stand-alone operation with enhanced feature design.

Incredible power and functionality
The four door intelligent access module fully supports the advanced Concept access control features: i.e. soft / hard / timed anti-passback, dual user, card and PIN, free access via timezones etc.

Connectivity

The 4 Door Access module is connected directly to the Concept RS485 LAN. Up to 64 of the 4 Door Intelligent Access Modules may be installed in a single panel system.

Four door, four reader access control module. (Expandable to 8 readers with expander board)
Maintains full access control functionality when communications to the Concept Controller are lost
Onboard 3 Amp power supply
Can have 8 terminals connected for card and PIN access

Expansion options

The Intelligent Access Module Expander Board
This board allows the Intelligent 4 Door Access Module to control up to 4 Doors with Card In / Card Out operation using 8 Card Readers. Part number 995013.

Features:

Four doors via four Card Readers (Expandable to 8 Card Readers with 995013)
On board 3 Amp supply
Four onboard lock relays
Optically isolated LAN input provides 5kV isolation for protection from surges
Separate valid, invalid and Door Open Too Long (DOTL) output for each door
Separate reed, tongue, request entry, request exit and arm inputs for each reader
All Card Reader interfaces operate with common magnetic swipe and Wiegand readers without the need for any additional interfaces
Onboard review buffer for offline operation
Each Card Reader may be independently configured, allowing a combination of Card Reader technologies
Door open too long pre warn function

Download data sheet


Physical
Cabinet Dimensions	702(L) x 358(W) x 85(D) (mm)
Installation Environment	0°C - 40°C @15 - 85% Relative humidity (non-condensing)
Cabinet Battery Bracket	To suit 12V 17AH Sealed Lead Acid battery
Electrical	PCB Versions	Transformer Versions
Mains Input Voltage	N/A	240VAC, 50Hz
Mains Input Current	N/A	500mA
Input Voltage to PCB	16-18VAC	16-18VAC
Fuse Protection	Separate fuses for Battery , Siren 1, Siren 2, LAN & Detector Power
Current Consumption
Total Current Limit	N/A	3A
Operational Current (No peripherals connected)	450mA	450mA
Operational Current (995013 connected. No peripherals connected)	610mA	610mA
Recommended allowance for battery charging	N/A	300mA
Available Current (for relays, detectors, auxiliaries , etc.)	Power Supply source dependent	2A
Inputs
Zone Inputs	8 General purpose Zone Inputs
Door Inputs	Door Reed, REX, REN, Arm and Tongue Sense per Door
Reader Ports	4 (Expandable to 8 using Intelligent Reader Expander 995013)
Outputs
Relay	4 (Typically used for door locks)
Physical Auxiliaries	24 (8 General purpose; Separate Valid, Invalid and DOTL output for each door)