The IP 4 Door Controller provides an advanced network solution for fully integrated access control, security and building automation systems.

This product combines a special Concept Control Module and two 2 Door Access Modules in a single convenient enclosure catering for all the I/O and processing requirements for access control, alarm monitoring and automation functions for up to 4 doors, 10 areas and 16 zones.

Two additional 2 Door Access Modules can also be connected to provide control of up to 8 doors. “Programmable Site Code” is also supported.

Enormous System Expandability!

While the IP 4 Door Controller provides a competitive solution for smaller sites, it is also ideal for large and multi-site systems where many of these units can be networked and managed as a single integrated system by our advanced Insight system management software.

Features:

• Four doors via four card readers (Expandable to 8 card readers with 2 x 995012)
• Provides general purpose zone inputs, siren outputs and strobe outputs
• 10,000 Users (expandable on request)
• Connect up to 4 LCD Terminals to RS485 LAN to provide PIN code and additional user operations
• All card reader interfaces operate with common magnetic swipe and Wiegand readers without the need for any additional interfaces
• Onboard review buffer for offline operation
• Each card reader may be independently configured, allowing a combination of card reader technologies
• No limit on the number of concept IP door controllers that can connected
• Soft or Hard Anti-Passback that functions across all doors
• Supports Dual User requirement and Card and PIN requirement
• Free Access options via Time Zones, Area, Status etc.
• Extended door access times for disabled users
• Four onboard lock relays
• Separate valid, invalid and Door Open Too Long (DOTL) output for each door
• Separate read, tongue, request entry, request exit inputs for each reader

Download data sheet

Physical
Cabinet Dimensions	640(L) x 320(W) x 112(D) (mm)
Cabinet Battery Bracket	To suit 12V 17AH Sealed Lead Acid battery
Installation Environment	0°C - 40°C @15 - 85% Relative humidity (non-condensing)
Electrical
Mains Input Voltage	240VAC 50Hz
Mains Input Current	Max 500mA
Input Voltage to PCB	16-18VAC, 50Hz
Fuse Protection	500mA
Current Consumption
Total Current Limit	2.2A
Operational Current (no peripherals connected)	700mA
Recommended Allowance for Battery Charging	300mA
Available Current (for readers, detectors, relays & auxiliaries)	1.2A
Inputs
Zone Inputs	16 General purpose zone inputs
Door Inputs	Door Reed, REX, REN, Arm and Tongue Sense per door
Reader Ports	4 (Expandable to 8 using 2 x 2 Door Expansion Kits)
Outputs
Door Outputs	Valid, Invalid and DOTL per door
Relay	4 (Typically used for door locks)
Outputs (open collector)	2