The Ethernet UART provides a 10Base-T ethernet connection between the Concept 4000 control module and Insight system management software. You can then monitor your installation over LAN, WAN, VPN or the internet. The dedicated IP based Insight protocol combined with 128 bit AES encryption allows you highly secure and seamless administration of multi-site access, security system and automation deployments. In addition to IP support, this module hosts up to three independent serial ports.
NOTE: If the “Automation” Comms Task format is to be used, the Multi-port Ethernet UART (Ethernet +3 port), must be fitted.
10Base-T ethernet connection to our Insight system management software
Available as single port (Ethernet + 1 serial port) or multi-port (Ethernet + 3 serial ports) modules
Serial ports enable connection to printers, PC's, FE3000 GSM units, third party automation systems or other similarly equipped products.
Concept LAN over Ethernet Interface (CLOE) provides a convenient interface for the Concept RS485 LAN to be distributed over standard TCP/IP Ethernet networks. Ethernet connectivity allows the Concept LAN to operate over an IP network architecture including 802.3i (10baseT) and 802.3U (100baseT) switching and routing equipment. Wireless communications can also be achieved using a wireless router and Ethernet / 802.11 point to point RF solutions.
The CLOE system supports the TCP/IP protocol with all data encrypted using 128 bit AES encryption. Security is monitored in all RS485 segments of the LAN providing alarms for network outages or module substitution conditions.
